How much water to run through a new fridge water filter
Most manufacturers tell you to run water after a filter change. They give different amounts, and in some cases the same manufacturer gives two. Here is each, with its source, so you can see the spread and follow your own manual.
| Brand | What the manufacturer says |
|---|---|
| Samsung | Samsung US: dispense several gallons of water to clear impurities or air, then reset the indicator light. Samsung's dispenser troubleshooting page says dispense approximately 2-3 gallons. Samsung US support |
| LG | LG: dispense about 2.5 gallons (9.5 liters). LG's steps also say: dispense 30 seconds, pause 60 seconds, repeat for a total of 5 minutes. LG: replace the filter |
| GE | GE: run water from the dispenser for 3 minutes (about 1.5 gallons); on models without a dispenser, discard the first few batches of ice. GE: top-freezer filter |
| GE (SmartWater) | GE: run water from the dispenser for 3 minutes (about 1.5 gallons) to clear the system; GE replacement article says approximately 1-2 gallons. GE: side-by-side filter |
| Whirlpool and Everydrop | Everydrop: with a cup, hold the dispenser 5 seconds, release 5 seconds, repeat until water flows, then continue about 2 more minutes. Whirlpool's own guide says to run four gallons through the line. Whirlpool: how to replace |
| Frigidaire | Frigidaire (general advice, not filter-specific): run water from the dispenser for about 3 minutes (1.5 gallons) to clear trapped air and carbon dust. Frigidaire: changing the filter |
| Kenmore | Unknown. Kenmore's pages we read give no flush steps. |
Why manufacturers say to do it
Whirlpool, LG and Frigidaire each say the flush clears trapped air and carbon dust or fine particles left over from manufacturing. GE says it clears the system and prevents sputtering. Whirlpool: how to replace LG: replace the filter Frigidaire: changing the filter
Ice maker note
GE says that on models without a dispenser you discard the first few batches of ice produced after replacing the cartridge. Frigidaire says to switch off the ice maker before changing the filter, so it does not pull water mid-change. GE: top-freezer filter Frigidaire: changing the filter
If the water sputters or the dispenser drips afterward
That is usually air in the line. See New filter leaking or no water after a change.
Then reset the light.
Sources for this page
- Fridge Filter Fun: how to change your refrigerator water filter (published 2026-03-10) — Frigidaire. Manufacturer blog article. Read 2026-11-18.
- Side-by-Side Refrigerator - How to Change the Water Filter — GE Appliances. Manufacturer support article. Read 2026-11-18.
- Top Freezer Refrigerator - How to Change the Water Filter — GE Appliances. Manufacturer support article. Read 2026-11-18.
- How to Replace the Water Filter in Your LG Refrigerator (help library, dated 2026-09-07) — LG Electronics USA. Manufacturer support article. Read 2026-11-18.
- How to replace the water filter in a Samsung refrigerator — Samsung Electronics America. Manufacturer support article. Read 2026-11-18.
- How to Replace Your Whirlpool Refrigerator Water Filter (Filters 1, 2, 3 and 4) — Whirlpool. Manufacturer guide. Read 2026-11-18.
Last verified: against the manufacturer pages listed on this page.